- Ifix scada sychronization drivers#
- Ifix scada sychronization driver#
I believe that this could be due to a fault in configuration of the CP.
Ifix scada sychronization driver#
However in both cases, in the end the driver gives a failed communication error and does not the poll the DBs.
then the driver initializes a disconnect.
When it is shown as synchronized the CP responds to the "connection request" with a "disconnect request". When the CP is not synchronized the CP does not respond to the connection request by the driver. The replication functions include database synchronization. iFIX clients now always connect to the Primary SCADA on startup and failover to the Secondary in case of a loss of the Primary SCADA or in case of a manual failover. My analysis of the packet transfer over the ethernet shows that The new Data Sync function replicates information between the Primary and the Backup SCADA server. i used 3 registers to make analogue signals.RA, RB, & RH.RA Ramp a value from 0 to 100 of the EGU range at a rate controlled by the RY register.RB Co. When sometimes it does synchronize (not certain what triggers it) the six driver still fails to poll the DBs, while returning the error "Failed Communication". The communication link has been operational for a long period but all of a sudden the cp1430 stopped synchronizing with the CPU. Ifix scada sychronization drivers#
Im working on a system which uses the six ethernet drivers for communication between the iFix scada and an s5 system via a CP1430 interface.
0 kommentar(er)
